1. Place the rice mill steadily on the workbench and plug in the power plug.

2. Determine the whitening time and adjust the timing knob.

3. Take out the thallium from the hopper, take 17-20g of brown rice (with a moisture content not exceeding 15%) and put it into the feeding hopper, allowing it to flow into the whitening chamber. First press the power button to start, then put down the thallium pressure.

4. At the designated time, the rice mill will automatically stop running. First, take out the discharge hopper and remove the bran. Insert the feeding hopper again, then take out the pressure thallium, turn the front handle to the right by degrees, so that the polished rice in the polishing chamber falls into the feeding hopper. Turn the timing knob to the 0 position, press the power button to make the sand wheel idle for a few seconds, so that the rice particles in the polishing chamber fall. Then pull out the rice hopper and sieve it to obtain the measured polished rice.

Please take a look at the operation methods of the rice mill shared above! Different specifications and models may vary!